/

Norbar Torque Test Equipment (0.1-25 Nm)

NORBAR TruCheck Plus

Compact and lightweight
0.1 - 25 Nm measuring range
User-friendly, simple and clear menu
Torque measurement accuracy is ± 1%
4 digit and big led display (Format: 00,00)
Supplied with a traceable calibration certificate
Creating document with computer free software
There are three torque units: N·m, lbf·ft and lbf·in.
Ideal for torque screwdrivers and small wrenches
Service, spare parts, calibration services in Turkey

norbar-trucheck-01-25-range-torque-calibrators

When putting a torque tester into an environment where people are not calibration specialists, concerns can arise with regards to incorrect selections being made and therefore the potential of incorrect tool setting and consequently joint failure.

These new TruCheck Models have been designed to calibrate Torque Screwdrivers and small Torque Wrenches up to 25 N·m.

Model	Test Range	Accuracy	Driver Type	Display	Sizes	Shipping Weight
#	Nm		Inch	**	mm	Kg
43250	0.1 - 3.0	±1%	¼" vertical hexagon (male)	4 digit LED	64 x 175 x 72	2.6
43251	1 - 10	±1%	¼" vertical hexagon (male)	4 digit LED	64 x 175 x 72	2.6
43252	1 - 25	±1%	¼" horizontal hexagon (male)	4 digit LED	64 x 175 x 72	2.6

MODE Button

1) Track Mode (‘trAC‘ is displayed). Display follows torque applied

2) Click Mode (‘CLIC‘ is displayed). Display shows first peak of torque applied. Serial data output of peak torque is automatically transmitted. Display automatically resets after 3 seconds. For use with ‘click’ type torque wrenches.

3) Dial Mode (‘dIAL‘ is displayed). Display shows peak of torque applied. Press RESET to clear the display.
For use with ‘dial’ and ‘electronic’ type torque wrenches.

UNIT Button

Press UNIT to change units of measurement.

RESET Button

Press RESET to reset display in Dial mode.
Serial data output of peak torque is also transmitted.
Press RESET to transmit serial data in Track mode.

LIMIT Button
1. Press LIMIT to enter target torque setting.

Display flashes between ‘SEt’ and the target torque setting.

Press MODE to increase target setting. Hold to increase speed of change.
Press UNIT to decrease target setting. Hold to increase speed of change.

2. Press LIMIT to enter ± percentage tolerance setting from 1 to 10%. Enter ‘0’ for no limits.

‘%’ and the ± percentage tolerance setting is displayed constantly.

Press MODE to increase ± percentage tolerance setting.
Press UNIT to decrease ± percentage tolerance setting.

3. Press LIMIT to finish. Display shows ‘FIN’ for 1 second.

norbar-torque-tester-delivery All equipment is shipped with the factory calibration certificate.
Calibration services in Turkey are carried out by the SURKON.